Can anyone help me out with a bit of lathe work, I need the centre of my trigger wheel boring out a little, its 150mm dia, and wont fit in my ML7's chuck.

Alternatively any hints on 'chucking it' for boring.

bolt it to the front pulley and put the pulley in the chuck?

Won't it fit in the chuck if you put the jaws in the other way round?

Has it got any holes in it that you can use to bolt it to a faceplate?

Neil

Tried the reverse jaws, not quite big enough.

Its a solid wheel, maybe I could drill it for a faceplate.

Will pull the pulley off and have a look, but I wanted to use the centre hole to register it centre on the crank bolt head.

Have you got a face plate?
2 min job if you have?

If you struggle pop it in the post and I'll do it for you for a beer

If you are stuck send it to me and i will sort it.

[Edited on 31/5/10 by madteg]