Board logo

last bits for iva retest
cd.thomson - 15/6/10 at 11:08 AM

Hi lads, any help with the below?

I would like to buy/borrow/steal some electrical trunking, medium thickness (12-15mm?) and a letter/number stamp.

to get my fog light switch to operate only with main/dip beam where is the best place to take power? Do I need to T off two power lines from both sierra switchgear outputs (dip/main) to the switch?

Could anyone advise the best way to make my gear gaiter IVA-able? Should I just glue a plain leather gaiter onto my grp tunnel?

Agriv8 - 15/6/10 at 11:34 AM

re gaiter a CV boot can work quite well

regards

Agriv8

40inches - 15/6/10 at 01:06 PM

quote:
Originally posted by cd.thomson
Hi lads, any help with the below?

I would like to buy/borrow/steal some electrical trunking, medium thickness (12-15mm?) and a letter/number stamp.

to get my fog light switch to operate only with main/dip beam where is the best place to take power? Do I need to T off two power lines from both sierra switchgear outputs (dip/main) to the switch?

Could anyone advise the best way to make my gear gaiter IVA-able? Should I just glue a plain leather gaiter onto my grp tunnel?


Convulated split? how much do you want?

cd.thomson - 15/6/10 at 01:14 PM

cheers mate, just this minute spent £40 on tubing and rubber beading though .

40inches - 15/6/10 at 01:19 PM

quote:
Originally posted by cd.thomson
cheers mate, just this minute spent £40 on tubing and rubber beading though .


Sometimes lifes a bitch, ain't it?

coozer - 15/6/10 at 01:20 PM

I have about 10m of split convolute... if only I came here earlier!

eznfrank - 15/6/10 at 04:30 PM

For the fog i took the feed off the dip because if you look at the table in the manual the dip is on in every combination they list.

stevegough - 15/6/10 at 04:50 PM

quote:
Originally posted by eznfrank
For the fog i took the feed off the dip because if you look at the table in the manual the dip is on in every combination they list.


If you do that, the fog will go off when you are on main beam - you need to take a supply from each as I understand it.

Good luck with your retest, Craig.