Board logo

Wanted - Lock nuts for Master Cylinder
spdpug98 - 3/8/10 at 10:19 AM

I am after a couple of lock nuts for Wilwood type Master Cylinders, I have 2 spare cylinders but no lock nuts.

I have been through my stash of nuts but cannot find anything to fit, it is a very tight thread

TIA

blakep82 - 3/8/10 at 10:20 AM

5/16unf i think?

[Edited on 3/8/10 by blakep82]

procomp - 3/8/10 at 10:54 AM

Hi

Yep 5/16 unf.

Cheers Matt

spdpug98 - 3/8/10 at 10:57 AM

Thanks, will try and somewhere I can get hold of a couple don't want to go and buy a pack of 10,000

blakep82 - 3/8/10 at 12:15 PM

quite a few on ebay. ok, so its about £3 inc post for 10, but thats ain't too bad is it?

spdpug98 - 3/8/10 at 12:29 PM

quote:
Originally posted by blakep82
quite a few on ebay. ok, so its about £3 inc post for 10, but thats ain't too bad is it?


Just seen them, but I only need 2

The worst thing is that you know you can buy a pack of 50/100 for that sort of money at a local suppliers (if I had one!!)

spdpug98 - 3/8/10 at 12:55 PM

Just ordered some, the cost of my time in faffing about far out weighs the £3!!!!

blakep82 - 3/8/10 at 01:01 PM

quote:
Originally posted by spdpug98
Just ordered some, the cost of my time in faffing about far out weighs the £3!!!!


yep, that was my way of thinking with it too. you're bound to take them off for some reason and lose one lol. i know i would. 3 quid ain't too much really