Has anybody got one hanging around localish that I could come a make a cardboard template from?

Would like to make the dust sandwich plate while I'm on holiday.

If you also had a pinto starter motor that would be ace as I've also a 15mm spacer to fab too!

Cheers

Rich

If no one can help - let me know, i'll try and make one and post it up for you next week.

Thanks mate, I'll let you know.

Cheers

Rich

Ive got one on CAD for the V6?

I made one up and sent it to Boggle (Barry). I know he had to 'fettle' it a little to get it spot on as I only used cheap cornflakes cardboard .

I know he has been having personal stuff to deal with recently though so probably not around on herre much at the minute.

JB

Thanks chaps, already got one on the pinto but am doing a zetec upgrade in the winter and need to make one suitable for type 9 and zetec so theres no big gaps.

Cheers

R

Rich,the pinto plate just needs a little bit welded onto the inlet side of the engine and two small bits cut from the bottom,where it fouls the rear seal carrier.
I just used the pinto plate.it took 5 minutes to fettle and for a chap of your abilities,it should take you no more.

Andy

Go to RetroFord and buy one!

quote:

---

Originally posted by coozer
Go to RetroFord and buy one!

---

Hello Richard

Ive got a loose type 9 to trace and a pinto starter in Leeds. pm me