I'm looking for a K series to type 9 bellhousing for my Spite project. Ideally, I'm after a flywheel, clutch and all the other bits too, but I'm open to ideas!

Oh, a hydraulic clutch would be a bonus too!

Caterham do one bellhousing
not too bad a price for what it is! you would have to check but i beleive it fits to a type 9
the hydraulic release is available from motor factors
Ray

[Edited on 31/10/10 by RAYLEE29]

The best source for these is Caterham owners who are upgrading to Duratecs (well, being rich, they would). Not sure of the best way to find one, though. There's a Caterham section on Pistonheads, might be a good idea to put a post on there.

Whilst I could buy a new one, and it's not too bad a price, if I can get one cheaper then so much better!

Already got wanted ads up on PH. I'm in no rush, as I have lots of rust to remove first!

Hi Simon,

Not a bad price given that it's from Caterham. These guys are the only other people i can think of but they don't list the K http://www.rwdmotorsport.com/bellhousings/cat_2.html

Another supplier of Caterham parts are these guys, not sure if this is a stock item for them or not, but worth a call http://www.redlinecomponents.co.uk/

Kind regards

John

Have you got the engine? I have a complete setup that I may sell if no one wants to buy my unfinished Indy. Engine has zero miles, cater ham bellhousing and sump. New cater ham starter motor.

All you really need is a rover PG1 bellhousing, couple of plates of metal, and make your own!

I thought fisher sportscars used to do one also.

quote:

---

Originally posted by interestedparty
The best source for these is Caterham owners who are upgrading to Duratecs (well, being rich, they would). Not sure of the best way to find one, though. There's a Caterham section on Pistonheads, might be a good idea to put a post on there.

---