Its a long shot I know.......

I've just got hold of a 2ltr Zetec, and i want to get it transplanted asap. The only part I'm struggling to get off the shelf are some engine mounts. I can't weld, so making them is out of the question, and i have tried many times to get a decent answer from Raw, who just don't seem to be interested. My initial email was responded too, but nothing since then


So does anyone have any? or could make some for beer tokens? I don't mind paying for parts, I just can't make em!

The current engine is a 1600 CVH, if that helps.

Cheers guys!

Im picking up my striker from Raw in the nexgt week or two (at last)
Will be coming with some Zetec mounts so can measure them up and take pics if you want get someone else to make them?
I guess it depends on if you chassis mount locations are the same as the current strikers.

Keep hounding Callum at Raw, to be fair they have been busy since they took over back in Aug/Sept, however I think they have only just realised they need to turn over some products to make some money.

Thats great Loggy thanks.

If nothing else then i could have some knocked up by a local fabricator. I'm assuming my mounting points would be the same, but i guess the chassis design may have changed slightly. If nothing else, its a good start!

I'll keep chasing Raw. You never know! I really want to cerack on with the change, I'm confident the rest of it should be too difficult.

speak to GBS. they have decent ones.

Hi

Forget email, ring up and speak to Martin - top bloke.

Might be tricky until Monday though, they're getting ready for / at the Autosports show until then..

Sure theres someone local on here who can make them.. if you where close to me I could do it for ya!