Board logo

Wanted:stainless mesh for a grill
RichardK - 30/1/11 at 10:13 PM

Need to fill the gap where my carbs popped through the bonnet on the pinto setup. fairly fine needed, suppose medium is the term??

5" X 13" or 127mm X 330mm mesh, so pretty small.



or does any body have another cunning plan, bonnet is ali. Was going to make a former out of mdf with a router to get the curved edge and then a male version slightly smaller that I can press together to get the shape then glue to the back of the bonnet with sikaflex, sound feasible.

Yes I know I will have to tidy up the exhaust outlet!

Cheers gang

Rich

mookaloid - 30/1/11 at 10:29 PM

How about this? Stainless Steel Woven Wire Mesh 1/8' App. - A4 Sheet on eBay (end time 04-Feb-11 19:28:39 GMT)

Although I have a feeling some kind person gave me some a while back which might be suitable

Humbug - 30/1/11 at 10:29 PM

A former sounds OK but it might be difficult with stainless mesh unless the strands are pretty fine - it's hard stuff!

RichardK - 30/1/11 at 10:42 PM

quote:
Originally posted by mookaloid
How about this? Stainless Steel Woven Wire Mesh 1/8' App. - A4 Sheet on eBay (end time 04-Feb-11 19:28:39 GMT)

Although I have a feeling some kind person gave me some a while back which might be suitable


Mmm, maybe a little course I think.

Stop press.....I think I may have found some on eblag....

RichardK - 30/1/11 at 10:47 PM

Sorted, thanks gang

daniel mason - 30/1/11 at 10:47 PM

naca duct?

swanny - 31/1/11 at 08:08 AM

darn, ive got some on top of a cupboard you could have had

paul