... so if someone would be so kind as to fabricate one of these for me, I'd be grateful, beer tokens are on offer.

It's for a Type9 extension.

*** Please give 0.05 mm approx. for fit ***

Please if anyone thinks the Diameter is wrong, please correct me.


Type 9 Extension

Full Size Picture

Thanks

EDIT to change title on advise

[Edited on 25/3/12 by RoadkillUK]

Hi Lee. Change your title to 'I need a part turning' and you'll probably get more positive responses.

I could do it for you but the delivery cost would put it too dear.

I can get one of the lads to do it towards the end of the week if you can't get it done any faster or aren't in a massive rush.
Presume it is steel rather than ali, not sure if it is my eyes going or a crappy pic viewer but some measurements are hard to read -drop us an e mail with measurements on Wednesday if you want us to knock it off, if I don't hear anything I'll assume you are fixed up.

atb
Mike

Thanks for the offer, but I've found a local place that will do it for me, thanks again.