Board logo

T304 - 50mm Bends Needed
T66 - 12/4/13 at 04:52 PM

Im after some u bends or elbows if anyone has some lying about, u2 me please



Ivan

Confused but excited. - 12/4/13 at 08:25 PM

I'm sure I have some in two different radii. Will check garage tomorrow mate.
I bought quite a few of them to make a manifold but turns out they are too large dia for what I need.
Guess I should have done the math first but hey, it's a learning curve, right?

T66 - 12/4/13 at 08:42 PM

Im finding most of it a learning curve........eeeek

ashg - 12/4/13 at 10:58 PM

316 is better for zorsts

T66 - 13/4/13 at 05:34 AM

quote:
Originally posted by ashg
316 is better for zorsts




I had only just mentioned this was a learning curve, apart from the better corrosion resistance of the 316 whats the difference ?