Board logo

WTD: Zetec Blacktop log manifold
pekwah1 - 20/11/17 at 02:59 PM

Hi Guys,

Just wondered if anyone has an intake manifold lying around suitable for a 2.0 blacktop zetec.
i intend to use it with the standard injectors and throttle body.

Thanks,
Andy

SJ - 20/11/17 at 03:43 PM

I think I have a plastic 1.8 one, which I believe is the same as the 2.0. I have a 2.0 one as well but the numpties delivering my engine managed to break it.

Would need to have a rummage in the garage to confirm though.

pekwah1 - 20/11/17 at 04:00 PM

Sorry, didn't write this very well, i'm after something that looks a bit like this:



[Edited on 20/11/17 by pekwah1]

SJ - 20/11/17 at 04:20 PM

Sorry - I see what you are after now.

Cheers

Stu

chris - 20/11/17 at 11:05 PM

GBS sell similar but pricey https://s18.postimg.org/b8gdksmex/plenum.jpg






[Edited on 20/11/17 by chris]

[Edited on 20/11/17 by chris]

[Edited on 20/11/17 by chris]

[Edited on 20/11/17 by chris]

knight19770 - 21/11/17 at 08:45 AM

Hi Andy,

Here is one that i have ordered from the Scottish kit car centre? Worth a look and they supply the standard ecu with pre wired loom aswell, all plug and play.


http://www.kitcarparts-scotland.co.uk/ford-2-0-zetec-maxi-torque-inlet-manifold/

Mike

blobster7 - 21/11/17 at 09:05 AM

U2u sent. Regards Jim.

angliamotorsport - 21/11/17 at 07:08 PM

Hi, I have an unused GBS zetec inlet and throttle body £150 plus post

tims31 - 22/11/17 at 04:56 PM

quote:
Originally posted by angliamotorsport
Hi, I have an unused GBS zetec inlet and throttle body £150 plus post


I've used one of these and it works fine. The only trouble I had with it in the Fury was the throttle arm, if you have your foot flat down and the rocker arms are fully extended it holds the throttle open

I got around this by reorienting the arm. See here

angliamotorsport - 22/11/17 at 05:09 PM

Good information but only needed if you have a Fury

tims31 - 23/11/17 at 03:54 PM

quote:
Originally posted by angliamotorsport
Good information but only needed if you have a Fury


Or maybe another Chassis with inboard shocks/dampers. Just a note of caution as I found out after purchasing one.

pekwah1 - 23/11/17 at 04:29 PM

thanks all, i now have a manifold sourced!