Im after a Ford ZETEC E Inlet Manifold to Suit ZX12R 46mm Throttle Bodies. The one i have works but isnt the best so after something a little better if anyone has one collecting dust before i buy a Danst one

I would highly recommend using the original throttle body rubbers with whatever manifold you get. I bought a DanST manifold and had a lot of issues trying to get a good seal with the fluro lined tube and jubilee clips. In the end I got a new flange cut from aluminium tooling plate and welded into my manifold. This allowed me to use the original bolt on rubbers which fit perfectly with my carbs. So the jubilee clips no longer slip off and I have resolved all of my air leak issues.