Board logo

SVA Bits
andyharding - 3/1/06 at 07:43 PM

Just sent off the SVA application today (Shrewsbury)!

I'm in need of all the bits to cover the front suspension and a Mountney steering wheel cover.

I suspect many of these bits will have fallen off SVA passed cars so u2u me if you want to sell them.

Cheers.

zxrlocost - 3/1/06 at 11:20 PM

andy Id phone them and ask if they allow steering wheel covers

might want the original sierra one or whichever on there

chris

Humbug - 4/1/06 at 08:15 AM

Not sure if he still has it, but zetec lent me his Mountney s/w pad... apparently it has been used for several SVAs before.

http://www.locostbuilders.co.uk/viewthread.php?tid=21249&page=2

My SVA tester was fine with the pad but it's probably good advice to phone and check with your local centre.

However, I agree that it is probably easier to use a Sierra wheel and swap afterwards... the only reason I didn't was that the Sierra wheel I had didn't have the centre horn push so I would have had to fill/pad the hole somehow - seemed like too much effort

andyharding - 4/1/06 at 10:06 AM

quote:
the only reason I didn't was that the Sierra wheel I had didn't have the centre horn push so I would have had to fill/pad the hole somehow - seemed like too much effort


Ditto

In fact I think I've chucked the wheel too.

[Edited on 4/1/06 by andyharding]