Board logo

sheet steel
Messenjah - 11/1/06 at 08:08 PM

hi guys,

if i was to say im looking for a large sheet of 3mm thick mild steel

155cm long by 80cm wide

with two square holes cut in it 20cm x 20cm

with the centres 17cm from the outside edge (on the long plane) and in the middle of the short plane


like this
roughly not to scale

emsfactory - 11/1/06 at 08:41 PM

and?

Messenjah - 11/1/06 at 08:44 PM

lol yeah shudve made that claer

anyone work for a company that could supply it ? delivered ??

DaveFJ - 12/1/06 at 11:59 AM

I've got that much 3mm sheet steel loafing around my garage, you'd have to cut it yourself though (I just mark it out and use the angle grinder - not accurate but good enough for most things....)

02GF74 - 12/1/06 at 08:20 PM

quote:
Originally posted by Messenjah
lol yeah shudve made that claer

anyone work for a company that could supply it ? delivered ??


there is man in watford that can do this - not sure about delivery but not too far from you so can't you pick it up?

[Edited on 12/1/06 by 02GF74]

emsfactory - 12/1/06 at 09:11 PM

U2U sent

Mark Allanson - 12/1/06 at 09:24 PM

quote:
Originally posted by Messenjah
lol yeah shudve made that claer

anyone work for a company that could supply it ? delivered ??



Carefully mark out, cut the outer shape with your hacksaw, chain drill out the centre squares and file to shape - you don't need companies unless you need a large number made up

gazza285 - 12/1/06 at 10:44 PM

quote:
Originally posted by Mark Allanson cut the outer shape with your hacksaw, chain drill out the centre squares and file to shape


It's in centimetres not milimetres. 1550mm x 800mm is a long way to saw 3mm plate with a hacksaw