Board logo

Zetec info
BKLOCO - 27/1/06 at 11:17 AM

Can anyone who has a 2.0litre Mondeo tin top haynes manual help me out?

I need some info for setting up my MegaSquirt.

I need to know wht the Max Torque figure is and at what revs it is developed and the max BHP figure and again at what revs.
The third spec I need is a little more obscure and I'm not sure it will be in the Haynes manual but I need to know how much fuel the standard injectors are capable of flowing, in either CC's per minute or lbs per hour.
Any help appreciated.
Thanks

ecosse - 27/1/06 at 11:32 AM

This site will help with the power figures, and I'm sure someone will have the injector info or know where it is

Cheers

Alex

stevebubs - 27/1/06 at 11:51 AM

if you ask, I'm sure there's a few people around here with base maps you can use as a starting point...

piddy - 27/1/06 at 02:56 PM

Try asking on This Group.

iank - 27/1/06 at 03:38 PM

Got Haynes book open

Pre 4/1998 100kW @ 6000 rpm
Post 5/1998 96kW @ 6000 rpm

No torque figures to be found, or injector flow rates.

suspiciously round numbers for rpm IMO

probably useless I'm afraid.

stevebubs - 27/1/06 at 04:19 PM

Locally, a search for "zetec map" turns up

this and this

and this

BKLOCO - 27/1/06 at 05:45 PM

Thanks for the replies so far.
I forgot all about the Zeetec Cat site
That has the power/torque figures I needed for generating the base maps.
I still need the injector flow figures if anyone can help. if not I guess it will be a call to the Ford Technical help line at £1.00 a minute

iank - 28/1/06 at 07:33 PM

Injector fuel rates are here (found link in PPC letters page )

http://www.rsparks.com/tech_ref/fuel_injectors.html

Will need the serial numbers of the injectors as the list is rather UScentric in the vehicles column.

stevebubs - 28/1/06 at 09:38 PM

quote:
Originally posted by BKLOCO
Thanks for the replies so far.
I forgot all about the Zeetec Cat site
That has the power/torque figures I needed for generating the base maps.
I still need the injector flow figures if anyone can help. if not I guess it will be a call to the Ford Technical help line at £1.00 a minute


If grey, they're apparently 330cc/min (just seen another post with this in)

BKLOCO - 29/1/06 at 01:28 PM

Thanks for that Stevebubs.
That sounds about right.
I was estimating about 500cc/min from some rough info I got from an Aussie tuning site that listed some Nippon Denso injectors
A value of 330 will give me a much better injection time in milliseconds as at 500 it was way too short.