We're gonna be messing about with a megajolt install soon and I'm thinking about the fitting a the toothed timing wheel.

The engine still has the pressed steel crankshaft pulley, so I'm wanting a proper steel jobby to begin with. Anyone have one knocking around ?

I was also wondering if there's anyone out there fabricating pulleys with the timing teeth incorporated ?

Cheers all

just ordered one this morning from:

http://www.trigger-wheels.com/

not the cheapest but the universal one is what i have used on the last 2 megajolt crossflow installs and is a good wheel easily bolted or welded.

dont bother with a second hand steel pulley new ones are only £27.50 from burton (Part No: FP224) and at least you know its a gooden, bought a second hand one last year and found out to my cost it had been clouted and was out of balance.

Mac

[Edited on 15-5-2006 by viatron]

Mark,
If it's any consolation, the CVH one doesn't fit the crossflow.
Cheer up

Marcus

if it doesn't fit get a bigger hammer?

er ok maybe not

Right, thanks all, looks like it's gonna be a aftermarket trigger-wheel somehow mounted on a steel pulley from Burtons, I still might buy a cheapo pulley from ebay to practice my butchery on

Cheers, Tony

Couln't be arsed to look up the ad, but here's a link to a link.........

Crossflow trigger wheel.