I am looking for a breakers that would be willing to sell me a complete wiring loom from a Toyota Corolla with the phase 3 4AGE engine (about 1991 onwards).

I am having severe problems getting my car running properly and have pinpointed the problem to incompatibility between 2 looms that i have butchered and joined together.

As there are very few of these cars around in my area i am trying to find a place that would remove, pack and post me a loom.

Any suggestions or recommendations appreciated.

Thanks

All depend how much you want to pay, also the engine loam is not 100% seperate from the rest of the car so you will end up with some plugs or cut off wires in starange places.

One of the three plugs that goes to the ecu does not even connect to the engine and goes to the dash etc wihich all runs through the car loam.

I had the whole loam from the front end of the car and still managed to cut a few wires off in the wrong places.

I think you really need to strp the loam out yourself to be sure you get all that you need.

Also where abouts are you might be able to offer some help.

Rusty,

I am in the far North of Scotland, so i assume that rules out you helping me in person

But i know what you mean about the loom connections etc. It is a real pain, not helped by the fact that there are very few of these cars lying about now.

Regarding cost, whats the going rate?, cos i really need the loom sorted to run the car. I want the car running again for the summer and am getting desparate now.

We got a hole car off ebay for £220 when we needed an engine but like you say they are hard to get we waited ages for that one.