Hello,

Looking for a Vauxhall 16V redtop and the bits to fit:
Bellhousing / clutch / fork / bearing etc
Inlet / outlet manifold
Ignition
Sump
etc. Any of these bits would be of interest.
Cheers
Steve

i have an exhaust header supposedly off a caterham, its steel and a 4-4 section. I cam get a pic if its of any interest..

I also have new and unused (bought for my engine rebuild and not used) brand new and boxed standard size piston rings and valve stem seals.

I also have a few sumps, a couple of standard cast ally which are problably useless and you probably already have one of but i do also have a steel 8v one which can be cut and shut a bit easier.

Ned.

I didn't make it clear enough, I also need the engine! The whole job lot. I am not too worried about the engine though as I am sure I will be able to pick one up from a scrappy at some point soon.

Thanks Ned for the exhaust offer, would you u2u me a cost please?

Steve