I'm after a 90 degree bend to allow me to connect 2 pieces of rubber fuel pipe (8mm internal diameter)

Or alternatively a 90 degree rubber bend.

Any ideas where from?

Demon theives do these:

http://www.demon-tweeks.co.uk/products/ProductDetail.asp?cls=MSPORT&pcode=FSEFPA9012

bit pricey, but as a last resort i guess!

Richard

Sorry, ignore my previous post! total rubbish!

The onlt thing i can find is a t-union, could do the job if you put a pipe stopper on one of the arms.

http://www.burlen.co.uk/partDetail.aspx?partID=52484

Nope, forget that one to. Have found the perfect elbow from Gates:

http://www.nfauto.co.uk/gates.htm

See IN-LINE REDUCERS, CONNECTORS & 'T's near the bottom of the page.

Richard

Or just bend a bit of copper microbore heating pipe?

[Edited on 11/6/06 by ReMan]

Car Builders Solutions lower on this page.

Have u got a hydraulics place near you like Pertek? Theyl have a wide selection of jouners and t pieces etc in stock.

I bought a brass 90 from www.chandleryworld.co.uk see their plumbing section. Cheers, Pewe