Board logo

Bike Carb Manifold
westf27 - 5/9/06 at 04:43 PM

Anyone got a bike manifold to suit 2 litre pinto.I have a set of kawasaki xrx 1200s to fit.If not other than Bogg Bros anyone else making these ?

jacko - 5/9/06 at 05:43 PM

Hi if you have a drill a file a hacksaw then you can make one and just get a welder to weld it for you there not to bad to make have a look in my archives under zx9r carbs Jacko

Quinnynw64 - 5/9/06 at 06:03 PM

I've managed to make a manifold too. Made out of ally plate and ally tube. Just got a mate to TIG it up.
Jacko - What did you have to do in terms of jetting to your carbs?
Cheers

pathfinder - 5/9/06 at 07:17 PM

If you don’t fancy doing it yourself I can get laser cutting and tig done for a very reasonable price, ali or stainless!

lsdweb - 5/9/06 at 08:15 PM

Altiss Engineering

Have a look at this previous thread

02GF74 - 6/9/06 at 09:08 AM

piece of pi55 to make if you can weld steel or better TIG ali.

the altiss ones like nice - anyone usedthem - some idea of cost?

lsdweb - 6/9/06 at 04:15 PM

They built the manifold etc shown in the other thread - not cheap but very nice. I sold the car straight after though, so never fitted the stuff!

TangoMan - 8/9/06 at 12:14 AM

quote:
Originally posted by 02GF74

the altiss ones like nice - anyone usedthem - some idea of cost?


Manifold for bike TB's onto Zetec is £240. Not cheap!!!