Board logo

Wanted: few inches of ~9.5mm ID steel tube
the_fbi - 3/12/06 at 03:56 PM

I need to increase the width between my seat runners. The lever which connects them is around 9.5mm diameter, so I need a couple of short (circa 4" lengths of some small diameter steel tube.

Something like 12.7mm OD and 2mm wall would be fine as I'll drill out the middle a bit to make it a snug fit.

Clearly I'm not going to be too picky so please let me know what you've got and how much please, posted.

Needs to be mild steel, not stainless.

ta
Chris

bbwales - 3/12/06 at 04:14 PM

B&Q have a selection of mildsteel tube, you might get what you need there.
regards
Bob

the_fbi - 4/12/06 at 11:58 AM

quote:
Originally posted by bbwales
B&Q have a selection of mildsteel tube, you might get what you need there.
regards
Bob

Good shout!

Just been, what an amazing selection of round, round tube, square, aquare tube, equal angle, unequal angle, flat in both steel and ally.

Prices were great too. Got 1m lengths of each of 10mm, 12mm and 15mm with 1mm walls for roughly £5.50.