Board logo

Sierra driveshaft
flak monkey - 24/1/07 at 04:38 PM

Has anyone got an old sierra drive shaft they dont want, or even just the outboard end of one? Or one with knackered CV joints.

Preferably close to south cov and going free...

Cheers,
David

John Bonnett - 24/1/07 at 04:41 PM

David

I have two Lobro type shafts that you are welcome to have but unless you can collect from Devon, postage may be the killer.

Best wishes

John

MikeR - 24/1/07 at 04:43 PM

what you thinking?

I may have some going free - depends if i sort out shortening my shafts for my de-dion.

how much of a rush are you in?

flak monkey - 24/1/07 at 04:46 PM

quote:
Originally posted by MikeR
what you thinking?

I may have some going free - depends if i sort out shortening my shafts for my de-dion.

how much of a rush are you in?


Hi Mike,

Someone on the race car team at uni wants one to measure up to base the rear stub axles on. After one ASAP. Though I am now doing him a sketch of what they look like and some rough arse dimensions anyway. Told him to just get the bearings and make it up from there, the lazy git!

David

worX - 24/1/07 at 05:00 PM

Hi David,
My (wrong ones) are sitting on the floor doing nothing if you want me to measure anything specific for you/mate.
Just let me know what you need and I'll let you know asap.
they are the push-in type though - not lobro

flak monkey - 24/1/07 at 05:04 PM

quote:
Originally posted by worX
Hi David,
My (wrong ones) are sitting on the floor doing nothing if you want me to measure anything specific for you/mate.
Just let me know what you need and I'll let you know asap.
they are the push-in type though - not lobro


Thanks very much. Doesnt matter what type they are, its the outboard end he is thinking about.

I have sent him the doodle i have done, and will see what he requests, if anything.

Thanks gents

Catpuss - 24/1/07 at 06:53 PM

If you want to borrow one for measuring up, I'm very near M1 J21a and you can pop round and borrow the one with the knackered CV joint.