Anyone within easy range of Ipswich got a knackered old x-flow cylinder head cluttering up a corner of their garage? I don't care what its condition is like, as long as the inlet side is intact. Don't need any add-on bits, just the basic casting, although inlet manifold studs would be a bonus.

I want to make an accurate inlet manifold without taking my current engine apart...

cheers,
David

Hi David
I have one but it is being used for the next week or so to do the same job (R6 Carbs), you are welcome to borrow it later if you can't find another.
Nick

If your anywhere near Cambridge at any time David I have on you can use. Its about time for another meet anyhow?

If you've got one I can borrow for an indefinite period then I would be most grateful.

I was wondering about a meet...
...I'll post something in the 'Events' area!

Got one with a crack sitting in the garage gathering dust.

Perfick!

[Edited on 28/9/07 by David Jenkins]

David, You have U2U.

ATB Dan.