I'm after the engine loom to fit my 893cc (1993) Fireblade engine.

If anyone can help please U2U me.

Or can anyone confirm which looms I can use off later bikes?

Thanks.
Mark.

This might help link

Kev,,,,,,,,,,,,,,

I already u2u'd Andy for the one he has, sorry.

Maybe he has more than one. But if not I have first dibs on it I'm afraid.

did you get any information on if any other looms fit the 893?

NOPE!

Taken of another thread by AB Performance
Hope this helps

Kev...............

quote:

---

You might know this already but the 3 generation of Carbed blades have different ignitor boxes -
All 893 have prefix MWO
919 RRT/v - MASA
919 RRW/X - MASG
You can run any of the engines on an MWO or MASA box but the 893 (MWO) has no input for the TPS and to get the best out of them you should match ignitor to motor.
The only problem this throws up is if your motor is an RRW/X your 893 loom will not have the pink wire for the imobiliser - you can get round this (if this is the case) by adding a pin to your ecu plug and feeding it with an ignition switched live through a 3.9v zenner diode. If you need to do this let me know and I will tell you which pin position to put the additional wire on
regards
Andy
AB Performance

---

So to me that would point in the direction that a 919 loom would fit, but I would have an extra Pink wire for the imobiliser that I don't have.