Come to assemble the xflow and sod's law the water pump pulley seems to of vanished.....

So if anyone has one. 1300 engine, end of pump is 4 bolt with reverse thread for viscouse fan incase it makes any difference

Cheers

G

I think I may have one as I changed to astandard pump. I will search the garage and let you know tommorrow. you can have it for free the only cost will be the postage.

Bill

Think i've got a spare one as well. If BillHoll can't find one u2u me. Again free apart from postage.

Dont know which it is but i have a spare pulley with the smaller offset you are welcome to. let me know via u2u if you want it.

Thanks for all the offers lads

Will keep you updated on my quest for the holy pulley

You might like to consider fitting a turned steel pulley - Burtons recommend changing the stock pressed steel one as they have been known to burst at high revs. In fact, it's their No.1 recommendation!

But the stock one will probably be fine, unless you are planning to rev the nuts off it all the time. Oh, hang on, this IS a Locost!

The standard item will let go.

The Burton route does make sense.

quote:

---

Originally posted by simes43
The standard item will let go.

The Burton route does make sense.

---

Oh yes... <blush>