Evening all.. When I first built my YB cossie the starter motor pinion when bolted on was always in contact with the flywheel, as a quick fix I spaced the starter out with washers, this time around after a cracked block repair can anyone shed some light on my flywheel?? Its a cosworth 9 hole machined down to pinto size and the ring gear put on. I bought it as is.
Heres a pic..




Does it look like it sitting too far back?? for the pinion to clear it would need to be flush with the face.
Should it be??
Ta

Looks ok to me
As I remember the ring gear sits on a locating lip
Clutch face is always proud so you can skim it if needed