obr_technology
|
| posted on 21/5/14 at 12:55 PM |
|
|
Lathe Work- Shaft Required
Hi,
Hopefully somebody will be glad of some beer tokens in exchange for two shafts I need making.
I've got the technical drawing and can supply the material if anyone is able to help.
To give an idea the pair of shafts are identical, roughly 200mm long and 34mm dia.
PM me if you can help and I'll send over the drawing or Solidworks file.
Cheers
Olly
[Edited on 22/5/14 by obr_technology]
|
|
|
|
|
tegwin
|
| posted on 21/5/14 at 02:05 PM |
|
|
Is your big shaft going to require much polishing!?
Sorry...couldn't resist.
Might be able to help if no one else can but I am pretty busy for the next week or so.
------------------------------------------------------------------------------------------------------------------------
Would the last person who leaves the country please switch off the lights and close the door!
www.verticalhorizonsmedia.tv
|
|
|
obr_technology
|
| posted on 21/5/14 at 03:01 PM |
|
|
Damn Autocorrect!
Sorry, this was meant to say 'LATHE WORK'!
|
|
|
obr_technology
|
| posted on 21/5/14 at 03:02 PM |
|
|
Haha, yes lots of polishing!
I should have also asked if anyone knows anywhere i can get heat treating done as i will need the shafts and a couple of gears heat treating.
quote:
Originally posted by obr_technology
Sorry, this was meant to say 'LATHE WORK'!
|
|
|
DW100
|
| posted on 21/5/14 at 03:39 PM |
|
|
Is it just lathe work or does it involve splines etc.?
|
|
|
obr_technology
|
| posted on 21/5/14 at 04:55 PM |
|
|
I'll PM you.
|
|
|
DW100
|
| posted on 22/5/14 at 09:12 AM |
|
|
Got your PM, I have a lathe but do not any facility to cut the keyways accurately.
|
|
|
obr_technology
|
| posted on 22/5/14 at 10:42 AM |
|
|
Thanks, i've got a mill at work so will ask if one of the lads could do the keyway for me.
If you don't mind i'll send over the drawing to see if it would be possible?
|
|
|
HowardB
|
| posted on 22/5/14 at 11:06 AM |
|
|
Tempered tools in Sheffield do heat treatment, - contact there is Mike Martin,...
Howard
Fisher Fury was 2000 Zetec - now a 1600 (it Lives again  and goes zoom)
|
|
|
obr_technology
|
| posted on 22/5/14 at 11:42 AM |
|
|
Thanks Howard.
|
|
|
nero1701
|
| posted on 23/5/14 at 09:23 AM |
|
|
I've lathes, mills and heat treatment at the college if you still need help, Located in Bromley
|
|
|
obr_technology
|
| posted on 23/5/14 at 11:11 AM |
|
|
You have u2u
|
|
|
