femster87
|
| posted on 29/1/15 at 11:50 AM |
|
|
Wtd: Injection ECU
I am after a cheap ecu to get my kseries running. Anything consider reasonably priced please. If you have anything please let me know.
|
|
|
|
|
garyo
|
| posted on 29/1/15 at 02:28 PM |
|
|
Presumably you want something mappable rather than a standard 5AS paired setup?
|
|
|
femster87
|
| posted on 29/1/15 at 05:00 PM |
|
|
Yes am after a mappable one
|
|
|
Pat_T
|
| posted on 29/1/15 at 05:53 PM |
|
|
I have a bog standard 1.8 K-series ECU you can have for £10 posted if that's any good?
www.instagram.com/patroclueus
|
|
|
femster87
|
| posted on 30/1/15 at 07:48 AM |
|
|
Thanks pat, but my engine is a 1.4
|
|
|
Ugg10
|
| posted on 30/1/15 at 09:25 AM |
|
|
If you want mappable injection and ignition then unless you are very lucky with a second hand buy "cheap" is not really an option. I
looked into this for my engine and even the prebuilt megasquirt is around the £500 mark. For K series then I would personally go for Emerald (k3 is
OK, k6 is the new one) as you can use it with the OEM plug and loom as far as I know and they have loads of K series maps. An alternative is Canems
which is about the most cost effective and comes with a flying lead loom. Finally there is the omex 600 again, similar to emerald but you will need
thier loom, these come up a bit more often on ebay. But as I have said £500 should be your budget as a minimum for a second hand named system and
don't forget the cost of setting it up.
emerald ecu k3 k6 ,mbe,dta lotus elise exige kit car
---------------------------------------------------------------
1968 Ford Anglia 105e, 1.7 Zetec SE, Mk2 Escort Workd Cup front end, 5 link rear
Build Blog - http://Anglia1968.weebly.com
|
|
|
Nickp
|
| posted on 30/1/15 at 04:17 PM |
|
|
Canems recently had an offer where you got the hardware for the full ECU for the same price as the ignition only ECU. It was about £300 IIRC and only
needs a software upgrade for about £50 I think. I got one  Might be worth calling him.
|
|
|
dave_424
|
| posted on 30/1/15 at 04:48 PM |
|
|
I picked up a pre-built megasquirt 2 with a 8 foot wiring loom for £300 off Gumtree so look for second hand megasquirts for a cheap option
|
|
|
femster87
|
| posted on 30/1/15 at 05:15 PM |
|
|
Thanks, I will keep a look out for a bargain. I have fitted a few over the years just looking a cheap one if I can
|
|
|
