peter030371
|
| posted on 18/12/19 at 11:05 AM |
|
|
Duratec Head
I am on the look out for a Duratec Head (2lt) as a project head to work on. I have a set of kent cams/springs to go in it. Ideally it will be a good
used high port head (see http://www.sbdev.co.uk/Duratec/Cylinder%20Head.htm) ready for a
complete refurb but anything considered.
What have you go?
|
|
|
|
|
se7ensport
|
| posted on 18/12/19 at 06:29 PM |
|
|
I do, I have one from a 2009 Focus with 8,000 on it. It’s the high flow/high port casting.
I actually have the whole engine, burns a bit too much oil and needs a rebuild / piston rings.
[Edited on 18/12/19 by se7ensport]
|
|
|
peter030371
|
| posted on 19/12/19 at 10:31 AM |
|
|
All sorted, don't you just love Locostbuilders  
|
|
|
