Lotusmark2
|
| posted on 19/9/05 at 10:45 AM |
|
|
bits of tube and plate
Hi,
I am knocking up a prototype diff mountand reversing setup etc and just need some odds and ends of tubing and plate, does anyone have some knocking
around that lives near wigan area that a few beer tokens can secure.
Mark
|
|
|
|
|
Gav
|
| posted on 19/9/05 at 11:02 AM |
|
|
I have some 19mm and 25mm RHS and best part of a sheet 3mm plate left.
How much tube do you need?
|
|
|
Lotusmark2
|
| posted on 19/9/05 at 11:12 AM |
|
|
What ever you have mate, got lots of bits and bobs to fabrcate (bike engine mounts etc) but think its a real waste to start cutting up fresh lengths
for prototypes and small fabrications (not to mention cost)
drop me an email if you like mate.
lotusmark2@aol.com
|
|
|
Gav
|
| posted on 19/9/05 at 06:50 PM |
|
|
email sent 
|
|
|
Kissy
|
| posted on 19/9/05 at 07:20 PM |
|
|
Just a suggestion - if you take a trip to your local steel stockholders you'll get all the offcuts you need if you make a donation into their
Christmas/Beer fund. They get better money that way, rather than selling it by the skip load with the swarf. Trust me, there'll be one near
you. Just make sure you draw up a list of the must have sections/lengths/wall thicknesses before the visit, or you'll come out with a load of
'not quite what I wanted' bits! HTH
|
|
|
Lotusmark2
|
| posted on 19/9/05 at 07:37 PM |
|
|
Cheers Kissy, Gav is helping me out
|
|
|
