Steve Lovelock
|
| posted on 30/5/06 at 03:20 AM |
|
|
Vauxhall 16V engine & bits to fit
Hello,
Looking for a Vauxhall 16V redtop and the bits to fit:
Bellhousing / clutch / fork / bearing etc
Inlet / outlet manifold
Ignition
Sump
etc. Any of these bits would be of interest.
Cheers
Steve
|
|
|
|
|
ned
|
| posted on 30/5/06 at 05:48 AM |
|
|
i have an exhaust header supposedly off a caterham, its steel and a 4-4 section. I cam get a pic if its of any interest..
I also have new and unused (bought for my engine rebuild and not used) brand new and boxed standard size piston rings and valve stem seals.
I also have a few sumps, a couple of standard cast ally which are problably useless and you probably already have one of but i do also have a steel 8v
one which can be cut and shut a bit easier.
Ned.
beware, I've got yellow skin
|
|
|
Steve Lovelock
|
| posted on 30/5/06 at 12:52 PM |
|
|
I didn't make it clear enough, I also need the engine! The whole job lot. I am not too worried about the engine though as I am sure I will be
able to pick one up from a scrappy at some point soon.
Thanks Ned for the exhaust offer, would you u2u me a cost please?
Steve
|
|
|
