locoboy
|
| posted on 11/6/06 at 09:16 PM |
|
|
90 degree connector required
I'm after a 90 degree bend to allow me to connect 2 pieces of rubber fuel pipe (8mm internal diameter)
Or alternatively a 90 degree rubber bend.
Any ideas where from?
ATB
Locoboy
|
|
|
|
|
jamesbond007ltk
|
| posted on 11/6/06 at 09:49 PM |
|
|
Demon theives do these:
http://www.demon-tweeks.co.uk/products/ProductDetail.asp?cls=MSPORT&pcode=FSEFPA9012
bit pricey, but as a last resort i guess!
Richard
|
|
|
jamesbond007ltk
|
| posted on 11/6/06 at 09:53 PM |
|
|
Sorry, ignore my previous post! total rubbish!
The onlt thing i can find is a t-union, could do the job if you put a pipe stopper on one of the arms.
http://www.burlen.co.uk/partDetail.aspx?partID=52484
|
|
|
jamesbond007ltk
|
| posted on 11/6/06 at 10:01 PM |
|
|
Nope, forget that one to. Have found the perfect elbow from Gates:
http://www.nfauto.co.uk/gates.htm
See IN-LINE REDUCERS, CONNECTORS & 'T's near the bottom of the page.
Richard
|
|
|
ReMan
|
| posted on 11/6/06 at 11:00 PM |
|
|
Or just bend a bit of copper microbore heating pipe?
[Edited on 11/6/06 by ReMan]
|
|
|
Dusty
|
| posted on 11/6/06 at 11:49 PM |
|
|
Car Builders Solutions lower on this page.
|
|
|
Danozeman
|
| posted on 12/6/06 at 05:24 AM |
|
|
Have u got a hydraulics place near you like Pertek? Theyl have a wide selection of jouners and t pieces etc in stock.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
pewe
|
| posted on 12/6/06 at 07:53 AM |
|
|
I bought a brass 90 from www.chandleryworld.co.uk see their plumbing section. Cheers, Pewe
|
|
|
