itguy
|
| posted on 17/1/07 at 08:53 PM |
|
|
Valve Spring Compressor - to borrow
Hi Everyone
Has anyone in Leicestershire got a 16v Valve Spring Compressor that I could borrow for a few weeks while I do my zetec rebuild?
I've got an OHV one but it doesnt fit (obviously) and as its something I'm going to use so infrequently I'm after a borrow if
poss...
Cheers
Will.
|
|
|
|
|
oliwb
|
| posted on 17/1/07 at 10:26 PM |
|
|
You can use a pillar drill (in fact its even easier to use a pillar drill and bit of pipe) - obviously if you have one! Oli.
If your not living life on the edge you're taking up too much room!
|
|
|
mike smith1
|
| posted on 18/1/07 at 11:10 AM |
|
|
If you are struggling pop down to your local engine rebuilders, he may have a yoke that will fit your existing valve spring compressor that will
enable you to get into the recess. (for a small amount of beer tokens)
If you are struggling i will have a look when i get home if i have a yoke lying around that mite do the job not 100% though
HTH
Mike
|
|
|
NS Dev
|
| posted on 18/1/07 at 11:13 AM |
|
|
yep, got one you can borrow, I'm just up the road from Mallory Park, other side of leicester from you but not too far
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|
|
.JPG)
