David Jenkins
|
| posted on 28/9/07 at 03:41 PM |
|
|
knackered x-flow cylinder head in Suffolk/Essex
Anyone within easy range of Ipswich got a knackered old x-flow cylinder head cluttering up a corner of their garage? I don't care what its
condition is like, as long as the inlet side is intact. Don't need any add-on bits, just the basic casting, although inlet manifold studs would
be a bonus.
I want to make an accurate inlet manifold without taking my current engine apart...
cheers,
David
|
|
|
|
|
x_flow57
|
| posted on 28/9/07 at 04:06 PM |
|
|
Hi David
I have one but it is being used for the next week or so to do the same job (R6 Carbs), you are welcome to borrow it later if you can't find
another.
Nick
|
|
|
rusty nuts
|
| posted on 28/9/07 at 06:22 PM |
|
|
If your anywhere near Cambridge at any time David I have on you can use. Its about time for another meet anyhow?
|
|
|
David Jenkins
|
| posted on 28/9/07 at 06:33 PM |
|
|
If you've got one I can borrow for an indefinite period then I would be most grateful.
I was wondering about a meet...
...I'll post something in the 'Events' area! 
|
|
|
rusty nuts
|
| posted on 28/9/07 at 06:40 PM |
|
|
Got one with a crack sitting in the garage gathering dust.
|
|
|
David Jenkins
|
| posted on 28/9/07 at 06:50 PM |
|
|
Perfick!
[Edited on 28/9/07 by David Jenkins]
|
|
|
scutter
|
| posted on 29/9/07 at 05:54 PM |
|
|
David, You have U2U.
ATB Dan.
The less I worked, the more i liked it.
|
|
|
.jpg)
