Mark G
|
| posted on 17/2/08 at 05:46 PM |
|
|
893cc Fireblade loom
I'm after the engine loom to fit my 893cc (1993) Fireblade engine.
If anyone can help please U2U me.
Or can anyone confirm which looms I can use off later bikes?
Thanks.
Mark.
|
|
|
|
|
Kev99
|
| posted on 17/2/08 at 05:58 PM |
|
|
This might help link
Kev,,,,,,,,,,,,,,
|
|
|
Dangle_kt
|
| posted on 17/2/08 at 05:59 PM |
|
|
I already u2u'd Andy for the one he has, sorry.
Maybe he has more than one. But if not I have first dibs on it I'm afraid.
|
|
|
Mark G
|
| posted on 17/2/08 at 06:25 PM |
|
|
did you get any information on if any other looms fit the 893?
|
|
|
Dangle_kt
|
| posted on 17/2/08 at 07:06 PM |
|
|
NOPE! 
|
|
|
Kev99
|
| posted on 17/2/08 at 07:21 PM |
|
|
Taken of another thread by AB Performance
Hope this helps
Kev...............
quote:
You might know this already but the 3 generation of Carbed blades have different ignitor boxes -
All 893 have prefix MWO
919 RRT/v - MASA
919 RRW/X - MASG
You can run any of the engines on an MWO or MASA box but the 893 (MWO) has no input for the TPS and to get the best out of them you should match
ignitor to motor.
The only problem this throws up is if your motor is an RRW/X your 893 loom will not have the pink wire for the imobiliser - you can get round this (if
this is the case) by adding a pin to your ecu plug and feeding it with an ignition switched live through a 3.9v zenner diode. If you need to do this
let me know and I will tell you which pin position to put the additional wire on
regards
Andy
AB Performance
|
|
|
Mark G
|
| posted on 17/2/08 at 08:06 PM |
|
|
So to me that would point in the direction that a 919 loom would fit, but I would have an extra Pink wire for the imobiliser that I don't have.
|
|
|
