grassracer
|
| posted on 17/9/08 at 08:44 PM |
|
|
X/flow manifold for bike carbs
Long shot but does anyone have a manifold lying about to fit bike carbs to a xflow motor, don't mind a bit of fabrication to make it fit.
Alternatively a plate cut to suit inlet ports would do !!
|
NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
|
|
|
will121
|
| posted on 18/9/08 at 11:33 AM |
|
|
i recently brought of ebay a basic steel plate cut for a zetec and in his advert said done other engines and materials, may be worth a search under
'zetec manifold'
alternatively will get contact when get home tonight.
|
|
|
rusty nuts
|
| posted on 18/9/08 at 05:45 PM |
|
|
I cut my xflow manifold flange out of 12mm thick aluminium using a wood working coping saw with plenty of cutting fluid . Used a manifold gasket as a
template after making sure the gasket matched the ports . Turned the stubs up to suit the T/Bs and got them welded up . Total cost about £55 and a bit
of time. Get the carbs first
|
|
|
.jpg)
