Craigorypeck
|
| posted on 20/10/12 at 08:32 PM |
|
|
Flywheel and ringear location- 9 hole YB
Evening all.. When I first built my YB cossie the starter motor pinion when bolted on was always in contact with the flywheel, as a quick fix I spaced
the starter out with washers, this time around after a cracked block repair can anyone shed some light on my flywheel?? Its a cosworth 9 hole machined
down to pinto size and the ring gear put on. I bought it as is.
Heres a pic..
Does it look like it sitting too far back?? for the pinion to clear it would need to be flush with the face.
Should it be??
Ta
|
|
|
|
|
snapper
|
| posted on 21/10/12 at 03:59 AM |
|
|
Looks ok to me
As I remember the ring gear sits on a locating lip
Clutch face is always proud so you can skim it if needed
I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)
|
|
|
