tks
|
| posted on 2/5/08 at 11:16 PM |
|
|
bias bar alloy end needed
i need the steel insert of a 7/16UNF biasbar. I need the small axle wich is pressed in the alloy part.
Anyone fancing to make me one???
it would involve some lathe (i think), drilling and 7/16UNF tapping.
please some one... ODP want me to buy a complete balancebar.....
also if anyone could only do the thread/ final drilling for me i would be well pleasured to offer some pounds...
regards,
Tks
 
bias bar needed
[Edited on 2/5/08 by tks]
The above comments are always meant to be from the above persons perspective.
|
|
|
|
|
marc n
|
| posted on 3/5/08 at 06:43 AM |
|
|
pretty sure we have a few spare, send me an email and i will check for you when i get to work on tuesday
cheers
marc
please email rather than u2u
direct workshop email ( manned 8am till 6pm )
www.mnrltd.co.uk enquireys to :-
chrismnrltd@btinternet.com
|
NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
|
tks
|
| posted on 3/5/08 at 08:40 AM |
|
|
okey sended the mail....
The above comments are always meant to be from the above persons perspective.
|
|
|
