madteg
|
| posted on 21/9/08 at 08:18 PM |
|
|
Wanted sierra drive shafts
Looking for flanged shafts (flanges on both ends, thanks.
(Lots of beer tokens at ready)
|
|
|
|
|
locoR1
|
| posted on 21/9/08 at 08:47 PM |
|
|
Take it the cosworth shafts didn't fit then?
I'm not even going to respond to the AA one, did my share of pi*S taking yesterday 
 
Description
Check out my CB500T Cafe Racer build diary
|
|
|
grusks2
|
| posted on 21/9/08 at 08:54 PM |
|
|
Ive got a pair, with hubs, new bearings in the hubs, shafts all been checked over and cleaned etc, boots in very good nick, i bought them for my Mac 1
but as im using a freelander diff i need sierra push in shafts not bolt on. I was going to put them back on ebay as they cost me a fair bit. They got
cossie hubs for larger rear discs as well.
I now need a set of push in shafts now.
http://mac1worxbuild.wordpress.com/
forgot my old password so another username doh
|
|
|
Myke 2463
|
| posted on 21/9/08 at 09:56 PM |
|
|
Hi Dave .
Your not the kind of guy i would expect to milk a situation like that, Take the p155 ? traction speaks louder than words,
Good standing time, nice one
Mike
|
|
|
jordanphd
|
| posted on 28/9/08 at 07:01 AM |
|
|
Driveshafts
Hi Dave,
I have a set, including stub axles, bolt on type. Good order, on ebay at the minute but can end early for the right price. Email me on
www.superfour400@hotmail.com
Check out below for loads of bits for sale.
http://www.haynes.co.uk/forums/showthread.php?p=6471#post6471
Ta
 
Rescued attachment driveshafts.jpg
|
|
|
