Board logo

Can anyone make me a couple of small alloy sleeves
maximill666 - 15/7/09 at 03:55 PM

I am looking for a couple of small alloy sleeves to be made.

Only 50mm long, 12mm in diameter, with an internal diameter of 6mm

Basically just a couple of sleeves to fit over M6 bolts. Can anyone help me out, beer tokens waiting.

Thanks.

trextr7monkey - 15/7/09 at 07:46 PM

I'm on holiday at moment could do them sometime next week, but strangelywe are in Liverpool On Saturday for a meal, I suggest you try Coozer
atb
Mike

cjtheman - 15/7/09 at 09:28 PM

b&q do ally tube with 6mm hole that i used for my front grill but i think o/d is just over 10mm
it was about £5 for a 1m lengh
hth
cheers
colin

Steve Hignett - 15/7/09 at 09:31 PM

I think I've got some tube that'll do that already, will measure it for you tomorrow...

maximill666 - 15/7/09 at 09:58 PM

quote:
Originally posted by Steve Hignett
I think I've got some tube that'll do that already, will measure it for you tomorrow...


Thanks Steve thats great

Mike if I get stuck I will u2u you next week, cheers

coozer - 16/7/09 at 07:10 AM

Yep, could easily help out there if I had the raw material... had a look and only got 28mm diameter atm...

Farway - 16/7/09 at 09:27 AM

Where you at?

Steve Hignett - 19/7/09 at 07:05 PM

Completely forgot all about this - Sorry...


I do have some, but it's 6mm ID and 12.67mm OD - I assume that will be ok?

If so then let me know your address and I'll bung some in the post this week!

ATB