May be of use ?

link

I must be missing the point somewhere, but I thought a type 9 bolted straight up to a Zetec? I'm sure someone will correct me if I'm wrong.....!

The standard bell housing does fit, but you have to fit filler plates and there are a few holes that you cannot use. But if you have got 50quid to spend then it's a good buy.

These b/h are for mt75 boxes so it says

The mt75 is an integeral bell housing ,if you read the questions at bottom then it says type 9 ?

I looked into this this is the bellhousing to fit a custom MCT75/MT75 gearbox made by Mitchell Cotts to a zetec engine.

see here

http://www.locostbuilders.co.uk/viewthread.php?tid=33362