Board logo

alloy tube for manifolds
theconrodkid - 26/9/07 at 06:46 PM

just been having a clear out at werk,we have some allot tube that may be ok for bike t/b or carbs,anyone got internal diameters and ill have a measure up and grab some

jacko - 26/9/07 at 06:50 PM

I used 40mm in side tube if that helps
with zx9r--e carbs

David Jenkins - 26/9/07 at 07:00 PM

I'm after 44 or 45mm OD, about 5mm wall thickness... (CBR600 carbs)

GaryM - 26/9/07 at 07:00 PM

Hiya

I've just measured the fzr600 Mikuni carbs that are destined for the Xflow and they are:

33mm ID, 38mm OD

How much is there?

Cheers
Gary

theconrodkid - 26/9/07 at 07:36 PM

ill have a measure morra,there are about 8-10 feet in 1 foot or so sections of the small size and a lot more of a bigger size,if they are usable sizes ill wisk them away before the pikies pay a visit

Confused but excited. - 26/9/07 at 08:34 PM

I wouldn't say no to two pieces of approx 33mm i,d., in exchange for for beer tokens, if there is any going.
Grovel, grovel.

JohnN - 26/9/07 at 09:00 PM

I'd be interested in any 38mm ID / 43mm OD for GSXR 600 TB's. ID is the important dimension, the OD can be turned down?
Thanks

garage19 - 26/9/07 at 10:04 PM

quote:
Originally posted by David Jenkins
I'm after 44 or 45mm OD, about 5mm wall thickness... (CBR600 carbs)


David think i may have some. Will have a measure up in the worshp tomorrow.

Doug.

David Jenkins - 27/9/07 at 11:44 AM

Cheers Doug!

theconrodkid - 27/9/07 at 05:52 PM

ive managed to liberate the bits that will fit in my car.
i have 2x10" lengths of 33mm id and 3x42inch lengths of38mm id ,both are 5mm wall.
if you are interested please u2u me with how much you want and ill chop n post

theconrodkid - 13/10/07 at 02:47 PM

ok i have 1 length of 33mm id that is 43",2X8" lengths and 15X31/2 bits left,anyone interested please u2u me