Hi took car out today, (sun was out), One quick blast from the lights resulted in bad slipping clutch, Car was fitted with ZX12 by MK Indy, I think its just standard clutch, Anyone can advice on what action I should take now, and phone numbers for parts advised.
cheers John:

Blimey- thats a bit hard core!! Where about in the world are you? It was bloody freezing today in the garage- even with the thermal boilersuit on I had to resort to a quick blast with the heater!!! Roll on spring....

Probably needs the clutch stack height adjusting, uses thicker steels to achieve this..

Dont fit barnet plates, they suck..

If its an A1 model, beware of the lack of lubrication issue which requires a lot of upgraded parts..

If your clutch is dry when you disassemble it, be prepared for a big bill!

just try the barnett springs

koen

www.zx12r-indy.tk

u2u sent...

Steve