anyone using one of these? any good??
Tig 200
If it's 4.5kW power input at 240V won't it need 18.75 amps to run it?
You might have to run it off a dedicated supply.
Worth looking into before you part with your hard-earned.
Neil
Looks similar to the Clarke range, but no, I haven't tried/bought one so can't comment beond that.
On the power front, the Clarke range are all single phase 230V, 5.4-5.7kW. I already have a separate supply for the compressor and the plasma cutter,
I'd expect to have to run yet another one if I ran this.
I am looking at a TIG though, but a fully capable AC/DC machine. Still well over 1K quid required, despite Chinese attention, so I'll wait a bit
longer
Only needs that number of kW flat out....
I got one of these
http://cgi.ebay.co.uk/TIG-WELDER-MMA-WELDER-200AMP-INVERTOR-PULSE-WELDER_W0QQitemZ190264277522QQcmdZViewItem?hash=item190264277522&_trksid=p3286.c
0.m14&_trkparms=72%3A1298%7C66%3A2%7C65%3A12%7C39%3A1%7C240%3A1318
with an offer of £150, top notch.
Cheers,
Bob
Splitrivet: Can you get a foot control for that one
[Edited on 5/11/08 by jabs]
quote:
Originally posted by jabs
Splitrivet: Can you get a foot control for that one
[Edited on 5/11/08 by jabs]