Can anyone help? I practising my TIG welding and seem to have a common problem.
I appear to get two pools. One on each piece of ally and they don't want to flow together and join into one.
The pieces are close, almost touching but this seems to be a problem. I've tried increasing the power but it burns through and I've tried
increasing the AC balance which doesn't help.
Is it just me or the settings?
Isn't at this point you add filler wire ?
Hmm. Yeah that would sound right. The filler tends to blob in front. Maybe its my technique then?
U2U your address, I've a DVD tutorial on TIG, I'll rip you a copy.
weld pool is not hot enough. you need lots more amps. do you have a pedal? the ideal is to wack loads of amps into the piece to get the weld pool
going then back off the amps once you are going.
if you dont have a pedal try this method
set the amps nice and high then set the slope out to 5 seconds. put the welder on 2T. start off with your finger on the button to get the pool nice
and hot so it joins, then as it starts to get away from you take your finger off the button and it will back the amps off, as the amps cool off give
the button a quick press to rise the amps again then off for a second or two then on and off keeping the heat in the pool. it gets easier the more
you try.
also make sure you really clean up the ali and the filler before you start then you can back off the cleaning to get better penetration.
A pretty obvious one from me but I found getting the tungsten closer into the corners helped this situation. This will required a less shaky hand.
There is a great video kicking around on the web by Ron Covell on TIG welding.
JC
The rod and the tungsten should be at 90* to each other and only dip the tip of the rod in the weld pool, don't try to melt the rod with the heat from the arc or you will touch the tungsten and have to sharpen it again.
quote:
Originally posted by SeaBass
A pretty obvious one from me but I found getting the tungsten closer into the corners helped this situation. This will required a less shaky hand. There is a great video kicking around on the web by Ron Covell on TIG welding.
JC
Cheers so far.
AshG that's helped a lot. I don't have a pedal yet, they're too dear and I'm struggling to find the right connector. They all seem
to be too small.
Breaker. I'm using a white electrode. A thin one it is which in itself seems alright.
You can use ceriated, zirconiated or pure tungsten for AC welding. I use ceriated as it can be used for DC as well so saves keeping two types.
Don't forget about lanthanated tungsten electrodes as well.
I haven't tried the others, but the lanthanated ones hold their tip very well and give you excellent puddle control.
I've just ben fiddling agin and turned the pulse on and set it high and managed to get a good line going of a couple of inches.
I've set the slope down and if I remember it used to stay on for a short time after releasing the button but it won't do it now. I'm
guessing it's my knob set up.
I'm getting the hang a bit. It seems that the puddle will flow a couple of 'blobs' or so without filler so I've no need to keep
ramming it in there and when I do it goes a good way. Just have to concentrate and not let it run away and blow through now. Well chuffed!