I want to bend back the end of my turbo drain pipe so that it doesn't kink at the end i.e. it goes straight on.

Any suggestions as to the best way to do it. It's 18mm o.d. and steel if it makes a difference.


[img][/img]

Put it in a big vice?

+ lots of heat and a longish bit of tightly fitting pipe stuck down the end to use as a lever.

Thats how i'd do it anyway!

Rich

Cut the kink off and use a longer piece of hose for the drain.

fill it with sand and pack it really well then warm it up red hot and bend a bit at a time keep warming it

second that sand is best ,or you could use a tight spring you get them from wicks in the plumbing depatment works a treat