LocostBuilders - powered by XMB

I need a shim made!!

number-1 - 7/6/14 at 07:57 PM

Can anyone point me in the right direction?

I need a tube/shim made for a motorcycle axle.......Stainless steel will be fine, Dimensions are OD 25mm ID 20mm D39mm....so its not very big! It needs a cut along the depth......something like this quality pic ive created lol

The cut is so it will pinch the axle when the fork lugs are tightened

Any ideas of who can make it and what i should be paying? Im in Aylesbury, Bucks

Cheers

N1

adithorp - 7/6/14 at 08:40 PM

How about THIS

Slightly longer and without the slit but ten mins with the angry grinder would sort that.

silverback - 7/6/14 at 08:44 PM

U2U reply

number-1 - 7/6/14 at 08:53 PM

Cheers for the replies chaps

Good find adithorp! Almost the perfect length! Maybe the 1mm difference wont make too much of a difference! I will re measure tomorrow

Silverback, ive replied to your U2U

adithorp - 7/6/14 at 08:55 PM

I was buying poly-bushes and crush tubes last week.