Board logo

Water cutting service?? Waterjet cutting service?
tks - 26/5/06 at 09:10 AM

Does anyone knows a good service where i could place an order for some ally plates i need??

think it will be a 80pounds order ore close to it.

(for those remember its for my transmission)

any one??

Tks


Slater - 26/5/06 at 09:51 AM

Try these guys, based up near Aberdeen.

http://www.poseidonengineering.com/index.htm

the linky thing worked, wow!.
Keith.

[Edited on 26/5/06 by Slater]


Simon - 26/5/06 at 07:15 PM

Just had my turbo in/ex flanges cut by

http://www.sciss.co.uk/

from 10mm stainless steel. Used a bit of thin card pressed against holes, and this is the result:



We use them a lot for work too!!

ATB

Simon


MikeRJ - 28/5/06 at 02:22 AM

Simon, could you give a rough price for a one off job such as a manifold flange?


Simon - 28/5/06 at 10:52 PM

Mike,

When my father gets the bill (I included it in quite a bit of stuff he was having cut!), I'll check to see if they split it out. If so, I'll let you know.

HTH

ATB

Simon


NS Dev - 31/5/06 at 03:11 PM

for stainless etc surely lasering is much cheaper than waterjet, or have prices changed a lot in the last couple of years?


MikeRJ - 1/6/06 at 11:01 PM

Thought lasering stainless was difficult as it is too shiny?


NS Dev - 2/6/06 at 11:58 AM

see where you're coming from Mike but there were piles and piles of lasered bright stainless at NSI when I was there yesterday!

Bit I liked best were the deep drawn stainless vessels that they were laser cutting ports into the walls of on their 5 axis laser, beauty of a machine!