Last year, there was a bulk buy where several of use purchased the below TIG welder.

Well, I have just decided to have a go (in anger) with mine, but cant find my manual. I know which bits connect where, but, can some kind fellow tell which knob does what 'Pre-flow, postflow' etc.

Cheers in advance,

The Baron.


[img]http:// [/img]

you need to flick that switch to " ON "

sorry just had too before someone else says it
jy

If you can U2U me your E Mail address I think i have a PDF Version

Regards

FRank

you can find it here : http://www.differently.net/files/TIG/ with a few more pdfs from the miller site for TIG welding
the manual is ACDC200aMP.pdf

Thank You

No probs, if you find anything on t'interweb useful on TIG thats an image/vid/pdf or something let me know and ill stick it in that dir, might help somone else

just ignore me!

I am an idiot

jy

[Edited on 7/11/07 by IndyJohn]

Gav,

vgood info best explanations I've seen ta

David

Have a good look at this link as its a useful amperage calculator, and also for the gas flow / size of metal etc.
Its a good starting point for us beginners.

Getting the settings right is a large part of getting a good weld.

Linky


Also do a Bit Torrent search for "TIG Welding Basics.avi" Its a 1/2Gb long training video. Well worth watching. The bloke is a bit boring, but it covers the subject well, and explains a lot. - Well worth downloading, and using in conjunction with the link above to the Miller calculator.
If you are new to this like I am, its a big help.

How much did you gets get them for?

IIRC it was about £400 with a pedal, torch and a few spares for it.