Hi,

I have made diagrams of the throttle body flanges i need to make. They look the same, but one is a mirror of the other - one has to go on the end of the manifold, and the other goes on the throttle body - with some silicon pipe in between. This is because there is not really enough height for the throttle body and a 90deg pipe in its original position, so im looking to relocate the throttle body...

Here is a link to the two images...

Would be good if they could be made of ali...

http://www.locostbuilders.co.uk/upload/manifoldEnd.jpg

http://www.locostbuilders.co.uk/upload/throttleBodyEnd.jpg

The pictures are big, so ill not post them directly on here...

Its basically a metal plate, with a 60mm hole in it. then over the hole, is a 60mm tube of about 30mm high...


Can anyone else me?