40inches
|
| posted on 4/10/11 at 01:13 PM |
|
|
Exhaust gas analyser calibration?
Have acquired a Protech Flux 5000 II analyser from a local MOT station, but I have a small! problem in that it completes the
10 minute warm up, leak test and zero calibration, then nothing, if I press the measure key it starts the process then immediately goes back to
standby.
On start up the message "next calibration due in -680 days" pops up, so I am assuming that when the calibration expires the machine goes
into sulk mode 
Does anyone on here have any experience with this machine and able to give some advice?
|
|
|
|
|
MikeCapon
|
| posted on 4/10/11 at 02:10 PM |
|
|
There's one here for sale on t'Bay. See what he has to say about calibration. Perhaps he might be able to help you.
GAS ANALYSER Protech Flux 5000 II | eBay
|
|
|
